Brivis Error Code 54

Error Code h01 54: Rollout Lockout. During a heat cycle, a flame rollout signal is detected with the maximum rollout events allowed exceeded.

Need help with your Brivis System?

    Please select accurately so we can provide you with the best service providers in your immediate vicinity.





    Call us at: 1300665137
    Or send us an email at: info@errorcode.com.au


     

    Brivis Fault Code 54

    Brivis Error Code 54 Rollout Lockout: During a heat cycle, a flame rollout signal is detected with the maximum rollout events allowed exceeded.

    For Heater Repair Tech Only

    Reason: This error indicates the unit has locked out, due to 3 consecutive flame roll outs detected, within a heating cycle. Service Check List: Service Check List: • Operate the heater and observe the behaviour during ignition. Determine which AFRO is causing the roll-out. Rollout on lower AFRO • During ignition, measure the ignition burner pressure and ensure it is within specification. Check that the correct injectors have been fitted and the gas type is correct. • Check that the vacuum pressure switch is the correct switch and functioning correctly. • Check for water gurgle noises being emitted from either the flue or the heat exchanger inlet ports (Water gurgle can be the result of premature condensation or a blocked condensate drain system on SP 6 models) • Check if the flue terminal or flue pipe has soot marks, indicating poor combustion and/or a possible blocked heat exchanger. Rollout on Upper AFRO • Check the burners for blockage. • Check the burners for correct fitment.

    SKU: 328 Category: Tags: ,