Need help with your Brivis System?
Brivis Fault Code 70
Brivis Error Code 70 Remote Microcontroller Shutdown Fail: This fault indicates that the remote microcontroller did not shutdown the heating cycle within the heating cycle shutdown time.
For Heater Repair Tech Only
Reason: This fault indicates that the secondary microcontroller did not shutdown the heating cycle within the heating cycle maximum shutdown delay time (tsdndelay=2.5s) allowed in response to a fault condition detected by the primary microcontroller (See Section 8-4.3.1, 8-5.4.1, 8-5.5.1). Service Check List: If error 70 has occurred in the past on this heater then replace the NG-2 Module For a first time Error 70 reset NG-2 Module then retry heater operation.